Error updating locale 7945
To start off with I have created a set of files that will help you get started, you can download the set here (download).
Inside the zip file are the following files: Let’s assume your phone’s mac address is 0023331BEA0A, we will need a file named SEP0023331BEA0xml for the phone to configure itself.
I'm using Switchvox Free 1.0 version, but it's WUI only so how do you load the SEP files?
I've turned off natting and I'll test it again when I get back to the office, but I don't have high hopes.
If the Cisco Unified IP phone is currently running firmware earlier than 6.0(2) on and you want to upgrade to 8.x(x), you must first install an intervening 7.0(x) load to prevent upgrade failure.
I have spent many hours working with the Cisco 7960 series phone and Switchvox.According to Cisco, when initiating a factory reset procedure certain information from the IP phone is erased while other information is reset to the factory default value, as shown in the list below: Information Erased: It is highly advisable to follow the firmware upgrade procedure in a non-working environment to ensure other phones are not affected (in case of an accidental reboot), and to avoid the freshly factory reset ip phones obtaining the working environment’s settings.Cisco IP phone SCCP firmware files version 9.2., 7965 & 7975 IP phones (latest version at the time of writing this article) are available at our Cisco IP Phone & ATA Firmware Download section. When performing the factory reset procedure we are about to describe it is important to keep in mind that the IP phone will lose all configuration files and phone application.7961G, 7961G-GE, 7941G, 7941G-GE Release Notes for Firmware wireless setup wizard-1.
• Displays Error with Extension Mobility, page 7 I am resolve an issue phone which has gone 05.
Lines 184 – 209 repeat the same information to add another active line key, you can continue adding sections like this for all eight line keys.